Ghar ke liye
CCTV Cable
kaise choose karein?
Everyone focuses on the camera. Nobody asks about the cable. That one oversight leads to noisy footage, signal drops and expensive rewiring. Yeh guide pehli baar hi sahi karne ke liye hai.
Yeh sawaal hamare customers roz poochhhte hain – “bhai bas 2-3 cameras lagwane hain, kaun sa cable lu?” And honestly, it’s the right question to ask. Most people obsess over the camera and completely ignore the cable. That’s the mistake that costs them later.
Choosing the right CCTV cable for your home isn’t complicated – you just need to know what to look for. Let’s break it down step by step.
Why does the cable even matter?
Here’s a real scenario. You buy a Rs. 8,000 4MP camera. Your installer runs Rs. 15/meter CCA coaxial cable. Six months later, the picture gets noisy in rain, night footage is grainy, and signal drops completely beyond 50 meters.
Camera ki galti nahi thi. Cable ki thi.
The cable works silently behind the scenes – you never see it, you never think about it. But when it fails, the entire system fails with it. No camera, however expensive, can compensate for a bad cable.
A customer from Noida shared their experience – their installer used CCA coaxial to cut costs. Eight months in, the connector rusted during monsoon and the picture went completely black. They had to redo the entire wiring – the rewiring cost more than the cameras themselves.
5 Steps to Choose the Right Cable
Analog or HD cameras (TVI, AHD, CVI) need Coaxial cable. IP cameras with PoE need CAT6. Simple rule – camera pehle, cable baad mein. Never pick the cable before you know the camera.
Measure the actual route from each camera to the DVR/NVR – not a straight line, but through walls, ceilings and corners. Add 10-15% buffer. For runs above 50 meters, step up to a higher quality cable grade.
This is the most important step. The cable spec sheet must say “Pure Copper” – not “CCA” or “Copper Clad Aluminium.” CCA looks identical but causes signal loss, heat buildup and connector failure over time. JUAA cables always use pure copper core – no shortcuts.
Outdoor cameras need double-shielded cable with a UV-resistant jacket. Indoor cameras are fine with standard coaxial or CAT6. You can use outdoor cable indoors – but never use indoor cable outdoors. One monsoon season will destroy it.
Analog cameras need a separate power cable – coaxial only carries video. IP cameras with a PoE switch run both power and video through one CAT6 cable. For home setups, PoE is significantly cleaner and easier to manage.
Which cable for which area of your home?
Every location in your home has different requirements. Har jagah ek jaisi zaroorat nahi hoti – what works for the living room won’t cut it at the main gate.
Runs are typically long – 30 to 80 meters. Pure copper RG6 coaxial is the right choice here. Double shielding is essential for outdoor EMI. UV-resistant jacket is non-negotiable.
Vehicle headlights and motors can cause interference. Use shielded coaxial or SFTP CAT6. If burying underground, always use armoured cable – regular cable will not survive.
Short runs, controlled environment. Standard RG59 coaxial or CAT6 both work well here. IP camera + CAT6 + PoE gives the cleanest indoor setup with minimal visible wiring.
Moisture and UV exposure are constant here. Double-shielded, UV-rated outdoor cable is mandatory. Use weatherproof enclosures or tape on all connectors to prevent water ingress.
Coaxial vs CAT6 – Quick Home Comparison
| Parameter | Coaxial (RG59/RG6) | CAT6 UTP |
|---|---|---|
| Best for | Analog / HD cameras | IP / PoE cameras |
| Max distance | Up to 200m easily | 100m PoE limit |
| Power over cable | No – separate wire needed | Yes – PoE |
| Installation ease | Simple – straight to DVR | Switch + IP config needed |
| Outdoor use | Double shielded version | Need SFTP variant |
| Future upgrade | Limited to analog | Future-proof – IP is the standard |
| Home cost | Lower upfront | Slightly more – but saves power wire cost |
Fresh setup with a budget? Go CAT6 + IP cameras. One wire does everything. Existing analog system ya long outdoor runs hain? Go Pure Copper Coaxial – no compromise here.
3 Mistakes Most Homeowners Make
1. Blindly trusting the installer
Many installers use whatever cable is cheapest – CCA, thin jacket, poor shielding. You need to ask directly – “Is this pure copper?” Ask for the spec sheet. Yeh aapka ghar hai, aapki security hai – don’t leave this decision to someone else.
2. Using indoor cable outdoors
Indoor cable jackets are not rated for UV exposure or moisture. One monsoon season and the jacket cracks, water gets in, and the connector rusts. Always use outdoor-rated cable for outdoor runs – no exceptions.
3. Only looking at the camera price
Rs. 6,000 camera + Rs. 15/meter CCA cable = system that fails in 18 months. Rs. 6,000 camera + Rs. 28/meter pure copper cable = system that runs for 7-8 years. Cable mein invest karo – it’s a one-time cost that protects everything else.
Right Cable. First Time.
Every Time.
Decide camera type first, then cable. Always go pure copper. Use outdoor-rated cable outdoors. Ask your installer for the spec sheet. Yeh 3 cheezein kar lo – cable ki wajah se kabhi problem nahi hogi.
Pure Copper. UV Resistant. Made in India.
Free shipping on all orders.